Project 300ZX [12] - Wheels & Tires


I'm creating this post just to continue with the series numbering, because I already told part of the story in yesterday's post. I also already published photos in G+ (complete with captions in each and every one of them!) You must read them all, no matter how boring.

The fun starts here.

Till later.

Comments

Post a Comment

Popular posts from this blog

RaspHousy part 1

Image
RaspHousy: house automation Part 1 There's some talk nowadays about the "connected home" or "smart home". I've seen some offerings in the local hardware store that attempt to improve upon tradicional HVAC (heating, ventilation & A/C) controls by learning your habits, or being able to connect to the internet. Same thing for sprinkler control but apparently much less advancement in that front. I've been attracted to the idea of a smarter way to monitor and control those things, but those offerings in the market are too limited and most of the time they're quite pricey. On the other hand, since the  Raspberry Pi  came out I've been trying to come up with an excuse to get one and do something. Hm, a project was essentially begging me to take it. So I did. I bought a Raspberry Pi, after deciding that I'd prefer that over an Arduino. Arduino is a nice programmable microcontroller with lots of I/O possibilities. But I decided I wanted t
Read more

Project 300ZX [5] - Shift knob / e-brake handle

Image
As you could see in the initial pictures I took of the car, the shift knob, e-brake handle and their boots were in a terrible condition. There's no way you can repair that, so replacement was the only option. The shift knob had some nasty scratches and its cover was missing (I think it originally came wrapped in leather but  now it was only the soft-plastic inner knob). The boot is synthetic leather and it was peeled everywhere. Those scratches on the knob come from a previous removal I think. The knob screws to the shaft, but to keep it in place, Nissan originally glues it with some blue Loctite. I've read that it's pretty hard to take it off; you need to wrap the knob in towels and then apply as much force as you can to break the glue with a pipe wrench or something. I assume this damage came from that process. I'm glad someone else did that ugly job for me, because I was able to simply unscrew the knob with my bare hands. I'm not sure why they did it and
Read more

Project 300ZX [11] - 'Tis the season for reupholstery

Image
I finally got a hold of my new trim kit for the Z interior, gray Alcantara with 13 pieces that cover all places that came with some suede-like fabric originally. I also ordered new leather covers for the seats (which are leather all-around, inlike the original covers with are real leather on the front and synthetic on the backs). Ordered from interior-innovations.com, for about $750 with shipping. Let's quickly remember the status of the seats and trim: Yeah, they needed replacement. So this is the 13-piece kit, more or less. The sections they cover are: Behind the seats: center piece and two side inserts Doors: one insert in each Center armrest Center console: left and right of the lower console, and left and right of the upper console. Glove box and small trim piece to its right Under the steering wheel The actual fabric is somewhat thinner than I imagined, but the surface is really soft to the touch and has a kind of orientation to the tiny little
Read more